Quality Of Cut Troubleshooting - Textron JACOBSEN TR3 Manual De Seguridad, Funcionamiento Y Mantenimiento

11 TROUBLESHOOTING
11.2

QUALITY OF CUT TROUBLESHOOTING

It is recommended that a "test cut" be performed to evaluate the mower's performance before beginning repairs.
An area should be available where "test cuts" can be made. This area should provide known and consistent turf
conditions to allow accurate evaluation of the mower's performance.
Another "test cut" should be performed after the completion of the repairs and/or adjustments to verify the
mower's performance.
Before performing a "test cut" to diagnose cut appearance and mower performance, the following items should
be verified to ensure an accurate "test cut."
1. Mowing (Ground) Speed.
2. Reel Bearing Condition and Pre-Load (End Play) Adjustment.
3. Reel and Bedknife Sharpness.
4. Bedknife Alignment to Reel.
5. Reel-to-Bedknife Contact.
6. Height-of-Cut (HOC).
7. Roller and Roller Bearing Condition.
11.2.1 WASHBOARDING
NOTE: Arrow indicates direction of travel.
Probable Cause
Mowing (ground) speed is too fast.
Grass build-up on roller.
Roller is out of round.
Mowing in the same direction.
Use of a groomer on cleanup pass.
SAFETY, OPERATORS & MAINTENANCE MANUAL
Washboarding is a cyclical pattern of varying cutting
heights, resulting in a wave-like cut appearance. In
most cases, the wave tip-to-tip distance is
approximately 6—8 in. (15—20 cm). Colour
variation (light-to-dark) may also be noticed.This
condition is usually caused by a rocking motion in
the cutting unit(s). This condition is found mostly on
mowers with multiple (suspended) cutting units, but
other causes can produce the same
result.Washboarding may also be caused by
variations in the turf.
Remedy
Reduce mowing (ground) speed.
Clean the roller and use scrapers or brushes.
Replace roller.
Change mowing direction regularly.
Groomers should be used only in a straight line.
JACOBSEN TR3
en-65