Publicidad
Idiomas disponibles
Idiomas disponibles
To avoid breakage:
Do NOT handle or
manipulate
the unit by the cooktop.
The counter-top around the cut-out should be flat and leveled
(see hatched area on illustration
1).
Before installing the unit, measure the heights of the two (2) cabi-
net sides (H1-4), front and back (see illustration
1) from the floor
to the top of the counter•
Level the range using the
four (4) leveling legs, so
that the height from the
floor to the underside of
the metal flange is greater
than the tallest cabinet
measurement
by at least
1/1 6" (see illustration
2).
Shave
Raised
Edge
to Clear
Space for a
1 1/2"Max.
I
(3.8 crn Max.)
I
311/2" (81 cm)
Wide Cooktop.
Slide the unit into the cabinet• Make sure the center of the unit is
aligned with the center of the cabinet cut-out•
Remove the protective
channels on each side of the cooktop
(if provided)•
The metal flange under each side of the cooktop
MUST be placed
/
over the cabinet countertop
for proper unit support•
The cooktop
should NOT rest directly on the countertop
(see illustration
2) or else
it could cause damage to the cooktop voiding the warranty•
Level the
unit if needed•
After the installation,
MAKE SURE that
the unit is supported
by the two front
leveling legs and the two adjustable
leveling wheels
and NOT by the
cooktop.
\
Illustration
1
1
successfully
"install the range,
the initial
level
height from floor
to underside
of
cooktop
frame
should be at least
1/16" taller than
cabinet sides as
measured in step
2.
Illustration
2
3
Publicidad
