cecotec CERAMICCARE AIRGLAM Manual De Instrucciones página 35

3. OPERATION
1. Wash and condition your hair.
2. Dry your hair with a towel and comb it.
3. Ensure that the mains voltage matches the voltage specified on the appliance rating label
and that the plug is earthed. Plug the appliance to a power supply.
4. Align the desired head with the air outlet and turn it to fix it to the body of the appliance.
5. Press and hold the on/off button to switch on the appliance: the air speed and
temperature will be set to 1 by default. If you change the settings, the device will save the
last setting for later use.
6. Air speed: repeatedly press the air speed change button to adjust the air speed. When
the speed is set to 1, the first speed LED will light up, from left to right. Press the button
again to set the speed to 2: the first and second LEDs will light up at the same time. Press
the button a third time to set the speed to 3: all three LEDs will light up at the same time.
Press the button again to return to speed setting 1.
7. Air temperature: repeatedly press the temperature change button to adjust the
temperature. When the temperature is set to 1, the first temperature LED will light up,
from left to right. Press the button again to set the temperature to 2: the first and second
LEDs will light up at the same time. Press the button a third time to set the temperature
to 3: all three LEDs will light up at the same time. Press the button again to activate the
cold air, the indicator lights will go out. Pressing it again will return to temperature setting
1.
8. Turn off the device by pressing and holding the on/off button and unplug it from the
power outlet when you are finished using it.
9. Automatic cleaning function: with the appliance switched off, press, and hold the
temperature change button for 5 seconds: the dryer will blow air out of the air inlet grille
for 20 seconds.
10. To remove the head, slide the release tab down, rotate the head and pull it gently to
remove it.
Using the curlers
1. With your hair at least 85% dry, place the curler on the side of the head whose hair you
wish to curl first.
2. Separate the hair into approximately 2 cm strands.
3. Select a warm or hot temperature setting.
4. Bring the end of the hair strand close to the curler: the latter will attract the hair thanks to
the Coandă effect and curl it.
5. Keep the hair wound on the curler for a few seconds and then release a shot of cold air to
fix the hairstyle.
6. Switch off the appliance and unwind the hair from the top. Repeat these steps with the
next strand until all hair on that side of the head is curled.
ENGLISH
Bamba CeramicCare AirGlam
35