Publicidad
Idiomas disponibles
Idiomas disponibles
When lifting the Robot Pool Cleaner, take care to prevent back injury.
CAUTION
Do not bury cord – locate cord to minimize abuse from lawn mowers, hedge trimmers and
other equipment.
CAUTION
This Robot is for use with permanently installed pools. Do not use with storable pools. A
permanently installed pool is constructed in or on the ground or in building such that it
cannot be readily disassembled for storage and reassembled to its original integrity.
CAUTION
SAVE THESE INSTRUCTIONS
2. FCC STATEMENT
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party responsible for
compliance (Maytronics Ltd.) could void the user's authority to operate the equipment.
3. SPECIFICATIONS AND WATER CONDITIONS
• Motor protection: IP 68
• Minimum depth: 0.40 m / 1.3 ft
• Maximum depth: 7 m / 22.96 ft
4. INTRODUCTION
This user guide describes how to operate your WAVE 200 XL and how to use your MMI console.
The interactive, state-of-the-art MMI (Maytronics Machine Interactive) control console enables full
control of the robot and allows you to determine the cycle time, operation delay, and cleaning scan
that the robot performs. It also enables diagnosis of various technical functions and parameters. The
console houses a remote control unit for manual operation and the temporary override of automatic
cleaning operations.
The WAVE 200 XL is designed to handle four different swimming pool configurations and when these
are set by your Maytronics dealer, the pool configurations are stored in the MMI's memory.
The robot is preset in the factory with specific default pool settings, which can be reset.
WAVE 200 XL
User Instructions
|
Power supply
• Input - 100-250 AC Volts
• 50-60 Hertz
• Output - <30 VDC
• IP 54
Use the Pool Cleaner in the
following water conditions only:
Chlorine
Max 4 ppm
pH
7.0 - 7.8
Temperature
6°-35°C / 43°-95°F
NaCl
Maximum = 5000 ppm
3
Publicidad
