Truma AquaGo basic Instrucciones De Funcionamiento E Instalación página 12

Sign Operating mode / Description
ANTIFREEZE
Prevention of freezing using 12 VDC
electricity:
Operating mode with installed
electric antifreeze kit (available as
an accessory) and appliance switched
on. The temperature in the appliance is
automatically kept above 41 °F (5 °C).
• During operation, the yellow status
LED 3 is lit.
Clean DECALCIFICATION
Only AquaGo comfort /
AquaGo comfort plus. See "Decalcifi-
cation" on page 17.
For safety reasons, after 30 sec-
onds the decalcification process
cannot be stopped until the system
has been rinsed in accordance with
the instructions. See "Interrupting
decalcification" on page 21.
Description of the yellow status LED 3
(see Fig. 9 – LED 3)
Signal Meaning
LED 3 lit Appliance is switched ON
LED 3 is off Appliance is switched OFF.
Refer to "Switching OFF the
appliance" on page 12.
Every 7 s, The appliance must be decal-
LED 3 is inter- cified
rupted for 1 s
LED 3 flashes Decalcification mode has
slowly 1 s on, been activated
1 s off
LED 3 flashes Before you use the water
quickly system you must rinse it (refer
to step f) "Rinsing the water
system" on page 19).
LED 3 flashes There is a fault in the appliance.
2 x briefly af- The exact fault diagnosis must
ter a break. be determined via error LED 2.
Refer to "APPENDIX A – Error
Codes" on page 37. Risk of
freezing if the temperature in
the appliance is below 37.4 °F
(3 °C).
12
Switching OFF the appliance
1. AquaGo comfort / AquaGo comfort plus
– Set the control panel to "Off".
2. Open the access door (refer to "Opening the
access door" on page 8).
3. Switch off the appliance at the POWER
switch (Fig. 8).
– The green Power-ON LED 1 (Fig. 8) extin-
guishes.
4. Close the access door (refer to "Closing the
access door" on page 9).
5. If the appliance is not needed, turn off the
gas supply to the appliance.
If you intend to put the RV into storage
or turn off the appliance during freez-
ing temperatures, refer to "Winterizing" on
page 14.