Truma AquaGo basic Instrucciones De Funcionamiento E Instalación página 21

Interrupting decalcification
Decalcification is indicated through slow
flashing (1 s on, 1 s off) of the status LED 3
(Fig. 9) on the control panel.
• Decalcification can be interrupted by switch-
ing the control panel to "Off".
– Decalcification is interrupted after about 2 s.
– The status LED 3 (Fig. 9) on the control
panel flashes quickly.
• Irritation of skin and eyes in
case of contact with decalcification agent.
Wear protective gloves, eye protection and
face protection to avoid contact.
• First you must take out the water inlet filter
and remove any AquaGo decalcification tab-
lets that it may contain.
– To take out the water inlet filter, see
"Draining the water and cleaning the wa-
ter inlet filter" on page 15.
– Dispose of AquaGo decalcification tablets
in accordance with local laws and regula-
tions.
• Before you use the water system again, you
must rinse it (see step f) "Rinsing the water
system" on page 19) and fill it with water
(see step g) "Filling the water system" on
page 20).
Accessories
Electric antifreeze kit *
Truma offers an electric antifreeze kit (part no.
77400-01) that keeps the appliance frost-free
to -4 °F (-20 °C) while you are driving or if there
is no gas supply. To operate the kit, you need
a 12 VDC (120 W) power supply from the ve-
hicle's on-board system. Ask your dealer.
* For AquaGo comfort / AquaGo comfort plus.
AquaGo decalcification tablets
Truma offers decalcification tablets (part no.
77300-01) to decalcify AquaGo comfort /
AquaGo comfort plus.
Truma rear installation gas connection kit
Truma offers a rear installation gas connection
kit (part no. 77000-37500) if installation from the
back of the appliance is required.
AquaGo comfort upgrade kit
Truma offers a kit (part. no. 77000-00005) to up-
grade from AquaGo basic to AquaGo comfort.
21