Husqvarna 325iLK Manual De Usuario página 11

is released. When you release the handle, the power
trigger and the power trigger lockout both move back to
their original positions. This movement is operated by
three independent springs.
(Fig. 14)
1. Make sure that the power trigger is locked when the
power trigger lockout is in its original position. (Fig.
15)
2. Press the power trigger and make sure it returns to
its original position when you release it. (Fig. 16)
3. Make sure that the power trigger and the power
trigger lockout moves freely and that the return
spring operates correctly.
4. Start the product, refer to
page 12 .
5. Apply full speed.
6. Release the power trigger and make sure that the
cutting attachment stops and remains still.
Safety instructions for assembly
WARNING:
manual together with approved accessory
manual.
• Remove the battery from the product before you
assemble the product.
• Use the approved protective gloves.
• A damaged or incorrect guard can cause injury. Do
not use a cutting attachment that does not have an
approved guard attached.
• Make sure that you assemble the cover and shaft
correctly before you start the product.
To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows. Do not place loop handle or suspension ring
on label. (Fig. 17)
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling. (Fig. 18)
2. Align the tab (A) with the arrow (B) on the coupling.
(Fig. 19)
3. Push the shaft into the coupling until it clicks into
position. (Fig. 20)
4. Tighten the knob fully. (Fig. 21)
1318 - 009 - 27.09.2023
To start the product on
Read this power unit
Assembly
• If a harness is supplied with the attachment, the
harness must be correctly attached to the product.
The harness makes operation safe and prevents
injury to the operator or other persons.
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
• Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling. (Fig. 22)
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the motor is
attached to.
4. Pull the attachment out of the coupling. (Fig. 23)
To install the suspension ring if
applicable
1. Install the suspension ring between the arrows on
the rear handle and the loop handle. (Fig. 24)
Note:
Do not put the loop handle on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.
Read the warning
11