Hinkley 990054FMB Instalación página 2

Safety cable clamp
Safety cable loop
Wood screw
and washer
Fig. 6
BLK (AC IN)
WH (AC IN)
Fan
Fig. 7
Hanger
Bracket
Canopy
Trim Ring
Fig. 8
Wood ceiling joist
GROUND
Outlet box
Ceiling
Groove
Screws
SAFETY CABLE INSTALLATION
Step 1. Attach the wood screw and the flat washer to the
ceiling joist as shown (do not fully tighten). Slide the
cable clamp onto the safety cable from the fan. Loop the
safety cable around the wood screw that was just
attached to ceiling joist. Feed the end of the cable into
the clamp and pull as much cable through as possible.
Firmly tighten screw in the clamp. Cut off excess cable
and tighten the wood screw to ceiling joist. (Fig.6)
ELECTRICAL CONNECTIONS
WARNINGS: Check to see that all connections are
tight, including ground, and that no bare wire is visible
at the wire nuts, except for the ground wire.
Connect the supply wires from the ceiling to the
receiver unit. (Use the 2 wire bundle on the receiver)
Secure with supplied wire nuts.
• Connect the BLACK building supply wire to the
BLACK receiver wire.
• Connect the WHITE receiver neutral wire to the
WHITE building neutral wire.
• Connect the COPPER building ground wire to the 3
YELLOW/ GREEN ground wires from the fan and
receiver.
Turn the wire nut connections upward, spreading
them apart so the green (ground) and white wires will
be on one side of the outlet box and the black wire
will be on the other side. Carefully tuck wires into the
outlet box space or evenly around the sides of the
hanger bracket.
CEILING CANOPY INSTALLATION
Step 1. Tuck connections neatly into ceiling outlet box.
(Fig. 8)
Step 2. Remove one canopy screw on the bracket
and slide the canopy up to mounting bracket and
place the key hole on screw on the mounting bracket
aligning the key slot in the canopy with the canopy
screw in the hanger bracket, turn canopy until it locks
in place at the narrow section of the key holes.
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure by
tightening the two set screws.
Step 4. Assemble the trim ring by aligning the two key
slots on the top side of the trim ring with the two
canopy screws. Twist to lock into place.
Referring to Facet fan installation instruction
for other ceiling fan installing procedure.