EN
FOR USA AND CANADA MARKET ONLY: SPECIAL WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
This model meets the government's requirements for exposure to radio waves. Your wireless device is a radio
transmitter and receiver. It is designed and manufactured not to exceed limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission (FCC) of the U.S. Government and by the Canadian
regulatory authorities.
The exposure standard for wireless mobile devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC and by the Canadian regulatory authorities is 1.6 W/kg.1.
For Canada market only: This EUT is compliant with SAR for general population/uncontrolled exposure limits in IC
RSS-247. The N-Com electronic device is positioned on a minimum distance of 30 mm from the head of the user,
therefore no SAR test have been conducted on the product.
Model: B902L R
PMN: N-Com B902L R
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.; any use of such marks by N-Com is
under license. Other trademarks and trade names are those of their respective owners.
FOR USA AND CANADA MARKET ONLY: WARRANTY
With this WARRANTY CERTIFICATE, Nolangroup warrants to the purchaser that the product, at the time of purchase,
is free from defects in materials and workmanship.
We kindly ask you to:
•
Read the warnings for safety and proper use.
•
Read the warranty terms and conditions.
•
Keep the original purchase receipt. This receipt must be presented in case of repairs under warranty. In these
cases, the product must be sent to the dealer where the purchase was made.
WARRANTY COVERAGE AND VALIDITY
If any defect covered by this warranty certificate is detected within the period specified for the country of purchase
(see table at the bottom of this leaflet) from the date of purchase shown on the receipt, Nolangroup will repair or
replace the defective product through its distribution network and after having verified the defect. Nolangroup will
provide all material and labour reasonably necessary to remedy the claimed defect, except in the cases where
damage is caused by one of the items listed in the following paragraph "Exclusions and limitations of coverage".
EXCLUSIONS AND LIMITATIONS OF COVERAGE
This warranty covers only defects in materials and workmanship.
Nolangroup cannot be held liable for product defects attributable in whole or in part to any other cause, including
but not limited to:
2
FCC ID:
IC:
Y6MNCOM15
9455A-NCOM15
R-NZ