GOAL ZERO Yeti Pro 4000 Escape Manual De Instrucciones página 4

Electrical Requirements
• Input Voltage: 9 V to 60 V
(Designed to work with Yeti PRO 4000 that provides 24 V.)
• Operational Current: 10 mA
• Maximum cable length: 30 ft
Associated Product Requirements
• This product is part of the Goal Zero Escape Towable and
Escape Driveable off-grid power kits.
• A Yeti PRO 4000 power station is required
What You'll Need
• Drill or Double Sided Adhesive
• Included Hardware
• Your choice of cable management (clips, adhesive, etc.)
6
Installation Instructions
NOTE:
• You'll want to decide where you would like to install the Escape Remote
Display. This screen should be visible and readable at eye level. It should
not be exposed to liquids and is intended to be mounted inside the cabin
of any RV.
• Back access of the mounting surface will be required to install the knurled
nuts. If desired mounting area does not have back access, double sided
adhesive can be used for mounting the screen.
• The Yeti PRO 4000 power station will need to be installed before moving
forward. Consider where cables will be running for mounting as well as
drilling into walls and or floors.
1. Connect the Escape Display Power and Data Combiner (DPDC) to the High
Voltage DC in on the Yeti PRO 4000 with the HPP+D on the DPDC.
YETI 4000 BACK INTERFACE
High Voltage
2. Neatly run the DPDC towards the area where the Escape Remote Display
will be mounted. Attach the DPDC to the floor or wall of the vehicle using
your cable management solution of choice. Ensure no other cables or pipes
will be damaged by installing securing clips.
3. Plug in the Escape Remote Display Data Cable to the Escape Display
Power and Data Combiner RJ45 port
3
2
2
7