GOAL ZERO Yeti Pro 4000 Escape Manual De Instrucciones página 5

4. Route the cable to the desired mounting position of the
Escape Remote Display.
5. Mounting the Escape Remote Display:
You can either drill into your wall (back access required) or adhere with
double sided adhesive. Before drilling holes, check to ensure there is
enough space for the screen.
• Install threaded posts to the back of the Escape Remote Display, or
adhere double sided adhesive to the back side.
1
4
• Mark mounting holes. Line your screen up with the wall to use as a
template.
• Drill all holes - M6 / 6.6mm
• Connect the DPDC on the back side of the Escape Remote Display
1
• Place the threaded posts through the drilled holes, and
HAND TIGHTEN the provided knurled nuts.
wall
1
6. Once the Escape Remote Display is installed, the Yeti PRO 4000 will
automatically recognize the screen's presence. If this does not occur,
please contact our support team at 1-888-794-6250.
8
1
OR
3
5
Using Your Product
Adaptive Brightness Control
The Escape Remote Display's brightness changes based on ambient lighting.
Keep the screen clean so the light sensor can work correctly.
Reading The Screen
Time to
Charge Level
Empty / Full
HRS TO HRS TO
FULL EMPTY
POWER IN
ERROR ERROR
DC AC TOTAL
AC AC
DC W DC
Power Input
Will appear
when solar
HRS TO HRS TO
charging
FULL EMPTY
POWER IN
ERROR
Operation
AC
error on the
DC
Yeti's AC / DC
input ports
AC Active
Input on Yeti
Power+ port
Referencing which port is being used.
DC - input from all DC sources
DC Active Input
AC - input from all AC sources
on Yeti HPP-D or
Total - Combine value of DC and AC
8mm Port
System's
Capacity
° F
!
C
! Too Hot to
Operate
POWER OUT
DC AC TOTAL
A
Units Being
W
12v
Displayed
A =Amps
W = Watts
POWER OUT
ERROR
DC AC TOTAL DC AC TOTAL
AC
A
W DC W
12v
° F
!
C
9