Descargar Imprimir esta página

MikroTik NetMetal 5 Serie Guía Rápida página 63

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
Antenna gain,
Antenna Model
Type
dBi
19D120
*The same type of antenna and lower antenna gain than those listed above in the table may also be
used in accordance with certification.
Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the FCC and IC
radiation exposure limits set forth for an uncontrolled environment. This MikroTik device should be
installed and operated no closer than 255 centimeters from your body, occupational user, or the general
public.
Innovation, Science and Economic Development Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science,
and Economic Development Canada's license-exempt RSS(s). Operation is subject to the following
two conditions: (1) This device may not cause interference. (2) This device must accept any
interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: 1) L'appareil ne doit pas produire
de brouillage; 2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [A] est conforme à la norme NMB-003 du Canada.
CAN ICES-003 (A) / NMB-003 (A)
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
Les dispositifs fonctionnant dans la bande de 5 150 à 5 250 MHz sont réservés uniquement pour une
utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites
mobiles utilisant les mêmes canaux.
Antenna Installation WARNING: It is the installer's responsibility to ensure that when using the
authorized antennas in Canada (or where IC rules apply); only those antennas certified with the product
are to be used. The installer should configure the output power level of antennas, according to country
regulations and per antenna type. Professional installation is required for equipment with connectors to
ensure compliance with health and safety issues.
Approved Antenna Table:

Publicidad

loading