Publicidad
Safety
All operations on Biotage
Selekt and Biotage
®
systems must be performed according to the user documentation
supplied with the system and its accessories; see "Biotage
Selekt Family User Documentation" on page 16.
Intended Use
Biotage
Liquid Level Sensor from Biotage is intended solely to
®
be used with Biotage
Selekt and Biotage
®
to detect solvent and waste levels.
Labels Used on the Biotage
Liquid Level Sensor Kit
All symbols used on the labels on the Biotage
Sensor kit can be referred to in the Biotage
Installation and Safety document (P/N 417511) except the
following symbol on Biotage
®
This device is approved by the Ministry of Internal
Affairs and Communications in Japan; see "MIC Giteki
Marking on Biotage
MIC Giteki Marking on Biotage
Liquid Level Sensor
Japanese Radio Law and Japanese Telecommunications
Business Law Compliance.
This device is granted pursuant to the Japanese Radio Law
(電波法) and the Japanese Telecommunications Business Law
(電気通信事業法).
This device should not be modified (otherwise the granted
designation number will become invalid).
FCC and ISED for Biotage
Liquid Level Sensor
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and Economic
Development (ISED) Canada's licence-exempt RSS(s) and
complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
Selekt Enkel
®
Selekt Enkel systems
®
®
Liquid Level
®
Selekt Family
®
Liquid Level Sensor:
Liquid Level Sensor" below.
®
®
®
L'émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d'Innovation, Sciences et
Développement économique Canada applicables aux appareils
®
radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
1. L'appareil ne doit pas produire de brouillage.
2. L'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Changes or modifications made to this equipment not expressly
approved by Biotage may void the FCC authorization to operate
this equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
»
Reorient or relocate the receiving antenna.
»
Increase the separation between the
equipment and receiver.
»
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
»
Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with FCC/ISED radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance of
20 cm between the radiator and your body.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites d'exposition aux
rayonnements ISED établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé avec un
minimum de 20 cm de distance entre la source de rayonnement
et votre corps.
Cet transmetteur ne doit pas être placé au même endroit ou
utilisé simultanément avec un autre transmetteur ou antenne.
Safety
3
Publicidad
