Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING/SAFETY RULE
Always check the condition of the tire to ensure that the tire isn't damaged. A damaged tire could suddenly burst.
TUBELESS READY TIRE MOUNTING PROCEDURE
It is recommended to strictly follow the instructions provided by the tubeless tire manufacturer, as well as the following general directions.
11.
Make sure the Tubeless Ready tape and the Reparto Corse Tubeless valve are installed.
12. Check the rim and, more specifically, the tire seat for any foreign objects.
13. Follow the tire's rotational direction.
14. Insert the first of the two tire beads into the rim groove.
15. Insert the second tire bead, starting from the valve bore area.
16. We recommend using soapy water, mounting fluid, or talcum powder to decrease friction between the tire and the rim during mounting.
17. Make sure the valve is fully open.
18. Inflate the tire without exceeding the maximum pressure indicated on the tire by using a compressor so that the tire bead sits on the edge of the rim.
19. Carefully check that the tire beads are evenly seated on the rim all the way around the circumference of the wheel.
20. Deflate the tire by pressing on the top of the valve and prepare tire sealant according to the manufacturer's instructions.
21. Raise the wheel, holding it upright with the valve at its highest point.
22. If it is possible to insert the sealant with a syringe, remove the valve core using a suitable tool, insert the amount of sealant
recommended by the manufacturer, and reinstall the valve core.
23. If no syringe is available, release the bead on one side of the tire, pour in the sealant, adding the amount recommended by the sealant
manufacturer, and reinstall the bead in the center channel of the rim.
24. Re-inflate the tire without exceeding the maximum pressure indicated on the tire and carefully check that the tire beads are evenly
seated on the rim all the way around the circumference of the wheel.
25. Rotate and shake the wheel so that the sealant can seal the interior surface. Apply soap and water to the tire to check for bubbles,
which indicate an air leak. Position the wheel so that sealant flows into the leak and stops it.
TUBELESS READY TIRE DISMOUNTING PROCEDURE
It is recommended to strictly follow the instructions provided by the tubeless tire manufacturer, as well as the following general directions.
15. Deflate the tire.
16. Beginning on the side opposite the valve, push one side of the tire with your hands until the bead is disengaged from its seat and drops
into the rim groove. Continue around the entire circumference of the wheel.
17. Starting at the valve, pull the tire with your hands until it comes off the rim. Then continue around the entire circumference of the wheel.
18. Do the same on the other side of the tire.
19. Completely remove one side of the tire before proceeding to the other side.
20. Remove the tire.
TIRE MOUNTING PROCEDURE WITH INNER TUBE
1.
Before installing the inner tube, make sure that the Manufacturer's Tubeless Ready sealing tape is not worn or damaged. If this is the
case, you must first replace the sealing tape (see instructions for replacing sealing tape), and only after the sealing tape is replaced
can you proceed with installing the inner tube.
2.
Install the inner tube and tire according to the manufacturer's instructions and the general instructions given in the previous section
"TUBELESS READY TIRE MOUNTING PROCEDURE" steps 2 through 5.
3.
After the inner tube and tire are mounted on the Wheel, insert the inner tube valve into the valve bore. Lift and flex the second tire
bead toward the first one for easier insertion without the risk of pinching the inner tube.
4.
Insert the valve into the valve bore, and then release the second tire bead by lifting it over the newly inserted inner tube.
5.
Mount the inner tube and tire according to the manufacturer's instructions, or alternatively follow the steps in the previous section
"TUBELESS READY TIRES MOUNTING PROCEDURE" steps 5 through 9.
10
Publicidad
