Worx Nitro WX844 Serie Manual De Instrucciones página 11

Staple type
Staple length
(18Ga narrow crown
staple)
Machine weight (bare
tool)
** X=1-999, A-Z, M1-M9 there are only used for
different customers, there are no safe relevant
changes between these models.
***Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
SUGGESTED BATTERIES
AND CHARGERS
Category
20V Battery WA3639
20V Charger
WA3880
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 60745:
a = 3.742 m/s
Vibration h
emission value:
Uncertainty K = 1.5 m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be used
in a preliminary assessment of exposure.
20V Cordless Narrow Crown Stapler
18 gauge
19 mm - 40 mm
2.8 kg
Type Capacity
2.0 Ah
2.0 A
L = 81.5 dB(A)
pA
L = 92.5 dB(A)
wA
3 dB(A)
2
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4. INTENDED USE
This tool is intended for finishing and trimming (interior
and exterior), such as door & window casing, door
jambs, baseboard, crown molding, cabinetry, cap and
shoe molding, molding, staircases, door & window
trimming, chair rail, brickmolding, hardwood flooring,
paneling, furniture, etc..
5. OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING: Keep the tool pointed away from
yourself and others when loading staples.
Always remove the staples and battery pack when
tool is not in use. Failure to do so could result in
possible serious personal injury
11
EN