Descargar Imprimir esta página

Worx Nitro WX844 Serie Manual De Instrucciones página 13

Grapadora de corona estrecha sin cable de 20v

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 39
Removing a jammed staple
Try to operate the tool for two
more times to confirm the staple
is jammed.
NOTE: Before removing a
jammed staple, open the
magazine(see fig. C1) and
remove all the staples.
WARNING: Always
remove the battery pack
first and wear safety gloves.
• Keep the magazine open.
• Pull up on the tool free jam
release and unhook the latch
• Make sure the tip of the driving
mechanism is in the initial
position, if not, insert a flat head
screwdriver into the tip of the
driving mechanism and push
back.
• Remove any bent staples
• Close the jam release and latch
• Reinstall crown staples and
reactivate the tool
6. MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery
use and storage is (0
C-45
o
The recommended ambient temperature range for
the charging system during charging is (0
Details regarding safe disposal of used batteries
At the end of the life of the appliance, remove the
battery pack safely before disposing of the appliance.
Do not throw batteries away or throw them in the
normal trash can. Also do not dispose of the battery
with the machine. Remove the used battery pack
from the appliance and dispose of it at the nearest
or convenient dedicated recycling facility. If in
doubt, consult your local environmental protection
department. Batteries may enter water cycle if
disposed improperly, which can be hazardous for
20V Cordless Narrow Crown Stapler
See Fig. H1,
H2, H3
C).
o
C-40
C).
o
o
ecosystem. Do not dispose of waste batteries as
unsorted municipal waste.
7. ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
8. TROUBLESHOOTING
Possible
Symptom
Causes
Tool does not
operate properly:
LED light flashing
No staples
5 times
LED light flashing
Battery is
2 times
low
LED light flashing
Tool is hot
3 times
Tool operates
Depth
properly, but
of drive
fasteners do not
isn't deep
drive fully
enough
Staple is
too long
for wood
hardness
Tool operates
Depth of
properly, but
drive is too
fasteners are
deep
driven too deep
Frequent empty
stapling
Jammed
staples or
damaged
staples
Possible Solution
Replenish staples
Charge the battery
pack
Wait until the tool
13
cools down
Adjust depth of
drive
Use staple length
that is appropriate
for wood
Adjust depth of
drive
Pull up on the tool
free jam release
and unhook the
latch. Check
whether there are
jammed staples
or damaged
staples inside. If
so, remove the
jammed staples
or damaged
staples in time.
EN

Publicidad

loading

Este manual también es adecuado para:

Wx844.9