Auping AVS Manual De Instrucciones página 26

5. Breakdowns
The table below gives possible solutions to malfunctions.
If you have any doubts contact your dealer.
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Important!
• A malfunctioning gas spring may cause the back section to come up utomatically
without remaining in a fixed position.
• Before consulting your dealer, please make sure that the operating cord and cord
guide can move freely and are not trapped between parts of the bed or mesh base.
GB24
_03QVU_4459 BW.pdf - pag.24
Cause
Caused by moving parts
touching each other.
The box spring is not
leveled because the
floor is not absolutely
flat.
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose when
the bed was moved.
The bed is not
positioned away from
the wall.
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
LET OP !!! Lage resolutie!
Search Solution
Apply Teflon spray.
Do not use oil.
Make sure the floor is
absolutely leveled.
Tighten parts.
Position the bed away
from the wall.
Remove those objects.
November 17, 2009