Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Do not attempt to replace the
built-in, rechargeable battery
yourself for the purpose of reus-
ing the shaver. This could result
in the risk of fire or electric shock.
Please contact your nearest au-
thorized Panasonic service cen-
ter.
1. Remove the protective cap, outer
foil frame.
2. After removing the inner blades
and before removing the screws,
lift out the inner blade mount (J)
with pliers (see fig. 6).
3. Remove the blade base top (b),
foil frame release buttons (c), two
screws (d) and blade base bot-
tom (8).
Remove the On/Off switch {f} and
switch cam (g) (see fig. 7).
4. Remove the housing (h). Re-
move three screws inside of the
end cap (i) (see fig. 8).
5. Take the chassis (j} out of the end
cap.
Remove the battery (k) from the
chassis (see fig. 9).
Caution
* Do not charge the shaver where
the temperature is below 0 °C (32
°F) or above 40 °C (104 °F), where
it will be exposed to direct sunlight
or a heat source or where there is
much moisture.
* Use only the included shaver
charging
adaptor
RE3-59
to
charge the ES2209 shaver.
*
Dry the shaver completely before
setting it in the charging adaptor.
Keep the charging adaptor away
from water and handle it only with
dry hands.
Do not use an extension cord to
connect the charging adaptor to an
outlet.
The shaver may not immediately
begin to charge after being placed
into the charging adaptor after use.
Allow the shaver to sit inthe charg-
ing adaptor for a few minutes and
check again to make sure that it is
being charged.
The outer foil is very thin. If handled
improperly, it can be easily dam-
aged. To avoid personal injury, do
not use the shaver if it has a dam-
aged foil or inner blade.
Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets, bath-
rooms or kitchen appliances. Do
not submerge the shaver for a long
time.
Do not wipe any part ofthe shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
Do not take the housing apart as
this can affect the watertight con-
struction.
Publicidad
