Descargar Imprimir esta página

Kenmore 68680 Guia Del Usuario página 7

Combinaci6n microondas campana

Publicidad

Idiomas disponibles

Idiomas disponibles

Removing
and replacing
the microwave
oven
Excessive Weight Hazard
Use two or more people to move and install
microwave
oven.
Failure to do so can result in back or
other injury.
If you need to remove your Microwave
Hood Combi-
nation for any reason, follow these simple steps:
To remove:
1.
Unplug microwave
oven or disconnect
power.
2. Remove filters and vent grille.
• If filters O are
installed,
push in at the
tab and slide filter to the
outside edge to remove.
• Remove the two
screws
_t from the top
of the microwave
oven
cabinet (the screws
located closest to the
front corners).
Do not
remove the screws
located towards
the center of the cabinet.
• Remove the vent grille _.
Set the screws and
grille aside. (If grille cannot be removed,
see pt. 4.)
3. After removing
all oven contents,
including
the
turntable
and support,
tape the door in the
closed position.
Then
remove the two bolts
(_ securing
the
microwave
oven to the
upper cabinet.
4. Hold microwave
hood combination
in place with
one hand. Pull hook
to release microwave
__
hood from mounting
plate. If grille cannot be
removed
(per instructions
in pt. 2.), insert a thin
looped wire or similar tool
through
an opening in
grille to pull hook.
5. Grasp the microwave
oven. Rotate the microwave
oven downward.
(Be
careful that door does
not swing open.) Lift off
the support tabs _) at
the bottom
of the mount-
ing plate. Set the micro-
wave oven aside on a
protected
surface.
continued
on next page
7

Publicidad

loading

Este manual también es adecuado para:

6868168682