Trust START-LINE ACCT-510 Manual Del Usuario página 4

EN
ACCT-510 KEYCHAIN REMOTE CONTROL
1. Insert/replace battery
Open the battery compartment with the
A
supplied screwdriver. Optional: Remove the
old battery.
Insert the (supplied) 3V CR2450 lithium battery
B
into the removed battery holder with the -
side facing up.
Make sure the switch (in the remote control)
C
is set to position 1. The other positions are
reserved for possible future functions. Put the
battery holder back in the remote control.
2. Send ON-OFF signal
Press the button on the remote control 1x shortly
to send an ON signal. The LED on the remote will
flash green 1x.
Press the button on the remote control 2x
shortly to send an OFF signal. The LED on the
remote will flash red 2x.
3. Pair receiver
Put the receiver in learning mode (refer to
the receiver's manual on how to activate the
learning mode).
When the receiver is in learning mode, send an
ON signal with the remote control.
You can also pair multiple receivers to the
remote control.
4
4. Control a receiver with the remote
control
Press the button on the remote control 1x shortly
to turn the receiver ON. The LED on the remote
will flash green 1x.
Press the button on the remote control 2x
shortly to switch the receiver OFF. The LED on
the remote will flash red 2x.
5. Unpair receiver
Put the receiver in learning mode (refer to
the receiver's manual on how to activate the
learning mode).
When the receiver is in learning mode, send an
OFF signal by pressing the button 2x shortly. The
LED on the remote will flash red 2x.