Automatic Power Saving Function; Restoring Factory Settings; Troubleshooting - Esoteric C-02X Manual Del Usuario

Automatic power saving function

(APS>***)
o The default setting is "30m".
If there is no audio input (continuous silence) from the selected input
source for the set amount of time, the unit will turn off automatically.
o Audio input from input sources other than the one selected
has no effect on the operation of the automatic power saving
function.
30m
30 minutes
60m
60 minutes
90m
90 minutes
120m
120 minutes
OFF
The automatic power saving function is disabled.

Restoring factory settings

(Setup>***)
You can restore the factory default settings, erasing all changes in
memory. Press the k/j buttons until "CLR" blinks, then press the
STANDBY/ON (setting) button to execute the restoration of factory
default settings.

Troubleshooting

If you experience a problem with this unit, please take a moment
to review the following information before requesting service.
Moreover, be aware that the problem might be caused by something
other than this unit. Confirm that connected devices are also being
used correctly.
If this unit still does not operate correctly, contact the retailer where
you purchased the unit.
The unit does not turn on.
e Check that the power cord is plugged into a working power
outlet.
e Check that the power cord is properly connected to this unit.
The unit automatically turns off.
e This is because the automatic power saving function turned it
off.
Press the POWER button on the main unit to turn it on.
Change the automatic power saving setting if necessary (page
21).
Remote control does not work.
e Turn the main unit on (page 13).
e If the batteries are exhausted, replace both of them with new
ones (page 11).
e The remote control will not work if there are obstructions
between it and the main unit. Point the remote control toward
the main unit and use it within 7 m (23 ft) of the front panel
(page 11).
A television or other device is operating improperly.
e This unit's remote control might cause some televisions with
remote control functions to operate improperly.
Cannot select input.
e Make sure the input source is not set to be skipped (page
20).
VOLUME knob does not work.
e If through output (RCA2) is set to THRU and the input source is
RCA 2, the VOLUME knob will not function (page 19).
Volume display blinks.
e The volume value exceeds the maximum total gain of this unit.
Lower the volume until the display stops blinking.
Since this unit uses a microcontroller, external noise and other
interference can cause the unit to malfunction. If this occurs,
turn the unit off once, and then restart it after waiting for
about one minute.
21