Mi-T-M Corporation GEN-3000-iMM0 Manual Del Operador página 18

THERE IS A PERMANENT CONDUCTOR BETWEEN THE
GENERATOR (STATOR WINDING) AND THE FRAME"
2. If the words "NEUTRAL FLOATING" is displayed on the
control panel of inverter generator. For inverter generator
provided with a floating neutral, please pay attention to fol-
lowing words:
i) THE GENERATOR (STATOR WINDING) IS ISOLATED
FROM THE FRAME AND FROM THE AC RECEPTACLE
GROUND PIN;
ii) ELECTRICAL DEVICES THAT REQUIRE A
GROUNDED RECEPTACLE PIN CONNECTION WILL NOT
FUNCTION IF THE RECEPTACLE GROUND PIN IS NOT
FUNCTIONAL
LINE TRANSFER SWITCH
If this generator is used for standby service, it must have
a transfer switch between the utility power service and the
generator. The transfer switch not only prevents the utility
power form feeding into the generator, but is also prevents
the generator form feeding out into the utility company's
lines. This is intended to protect the serviceman who may be
working on a damaged line.
THIS INSTALLATION MUST BE DONE BY A LICENSED
ELECTRICIAN AND ALL LOCAL CODES MUST BE
FOLLOWED.
ENGINE OIL:
Before checking or refilling oil, be sure generator is located on
stable and level surface with engine stopped.
1. Remove oil dipstick and check the engine oil level. (Fig. 8)
2. If oil level is below the lower level line, refill with suitable
oil to upper level line. Do not screw in the oil dipstick when
checking oil level. (Fig. 9)
3. Change oil if contaminated. (See "Maintenance Schedule;
Changing Engine Oil" page 30.)
Oil Capacity ...................... 16.9 oz. / 0.5 liters
Recommended Oil............. SAE SJ Low-40
Recommended engine oil:
Use 4-stroke automotive detergent oil of API service class
SE or higher grade (SG, SH or SJ is recommended). If single
viscosity oil is used, select the appropriate viscosity for the
average temperature in your area. (Fig. 10)
18
Preparing the Generator
Engine Oil Dipstick
(Fig. 8)
Upper limit
(Fig. 9)
(Fig. 10)
Operator's Manual