afx light MASTBAR-BAT Manual De Instrucciones página 7

sponding function menu. For example, Static Colour, Macro, Show and Sound. Use the UP/DOWN
keys to select between the functions. When you press the ENTER button, the display will move to
the next menu item. Pressing the MENU button will return to the previous menu mode. The param-
eters are automatically stored after selection.
"User Settings"
Select "User Settings" (setting the user console mode) and press the ENTER key to confirm.
The display will show the channel options. Use the UP/DOWN keys to select "6Ch" (6 channel mode)
or "10Ch" (10 channel mode). If you press the ENTER button again, the menu will automatically
switch to "DMX512" address setting mode. Use the UP/DOWN keys to select the address code to
be set from 1 to 512. Once selected, the parameters are automatically saved. Press ENTER again to
return to the main display. When a DMX512 signal is received, the display will show "Connection".
When the DMX512 signal is disconnected, the display shows "Disconnect". If you press the ENTER
or MENU button, the display will return to the previous menu mode.
If you wish to use this function, please refer to the following diagram to set the DMX512 addresses
of the first 4 fixtures:
6CH mode: 1: A001, 2: A007, 3: A015, 4: A022
10CH mode: 1: A001, 2: A011, 3: A023, 4: A035
"Slave" mode
Select "Slave" and press the ENTER button to confirm. The message "Slave Mode!" will be dis-
played. After selection, the parameters are automatically saved. When the host signal is received,
the interface displays "Connection". When the host signal is disconnected, the interface displays
"Disconnect". If you press the ENTER or MENU key, the display will return to the previous menu
mode.
"System Settings"
Select "System Settings". Press the ENTER button to enter the next menu. Use the UP/DOWN keys
to select the function you want to adjust. Press the ENTER or MENU button. The display will return
to the previous level menu.
MASTER / SLAVE MODE
If multiple devices are connected in Master / Slave mode, select "Slave" for all devices connected
after the Master. Press ENTER to confirm. "OK!" will be displayed. This means that Slave mode is
active. After selection, the parameters are automatically saved. If the master signal is connected,
"Connection" will be displayed on the screen. If the DMX512 signal is disconnected, the screen dis-
plays "Disconnect". If you press ENTER or the MENU button, the screen will return to the previous
menu. The first fixture in the chain is the master, from which all performance modes must be se-
lected. The slaves are controlled by the master to perform the same actions.
WIFI OPERATION MODE
Download and install the "LED LAMP" appli-
cation from the PlayStore or AppleStore.
In the "User Settings" screen, press the EN-
TER button. Use the UP/DOWN button to
select "WiFi Mode". Press the ENTER button.
The WiFi icon will appear, indicating that
the WiFi module is turned on. Now open the
"Settings" on your mobile phone, find the
"Wireless" and "Network WLAN" items, and
connect to the device named LED_xxx, as
shown in the figure.
If the connection is successful, exit the phone's function settings and open the "LED LAMP" applica-
tion. You can now select the appropriate operating mode. The interface of the application and the
www.afx-light.com
7 EN