Publicidad
Idiomas disponibles
Idiomas disponibles
EN
12.1.
Sharing music via Bluetooth (A2DP Sharing)
During the intercom connection, you can start playing music by briefly pressing the "ON" key. The
music will be played in both systems.
Music sharing temporarily cuts off the intercom conversation; however, this can be automatically
restored by stopping the music (this is done by briefly pressing the "ON" key).
N.B.: Music shared through the intercom can be managed by both systems, for example, both
systems can change the track by pressing the relative command.
N.B.: When the "Audio Multitasking" function (chapter 16) is enabled, the "Music Sharing" function is
temporarily disabled.
N.B.: the "Music Sharing" function can only be used with the N-Com series "600"/"900".
13. MUSIC VIA CABLE
Connect the mini USB connector of the Multimedia Wire (not included) to the helmet and the other
end to the audio device. A coloured band on the cable indicates the connector to be hooked up to
the audio device.
Turning on the cable audio
Turning off the cable audio
N.B.: While listening to music via cable, it will not be possible to keep the intercom connection active.
14. NAVIGATOR PAIR UP
B902 system is compatible with the most common satellite navigators for motorcycles. For a list of
compatible models and additional details, visit the website www.n-com.it
•
Make sure the B902 is turned off.
•
Put the system in the "Pairing up" menu: press the "ON" key and keep it pressed for 4 seconds,
until you hear the voice announcement "
•
Press the ""key until you reach the option "
•
Activate the search of Bluetooth devices on the navigator.
•
Select the N-Com system from the list. If a password is requested, enter the code 0000 (four
zeros).
•
After a few seconds, the connection between the two devices is activated.
N.B.: The pair up is stored by both the helmet and the navigator hence it is not lost when they are
switched off. This means that this procedure needs to be carried out only once. Once the Bluetooth
device has been paired up, connection is automatic when the system is turned on.
N.B.: Intercom connection is automatically cut off every time the navigator gives directions and
restored at the end of the message from the navigator.
Should you wish to keep the navigator audio active even during the intercom connection, please
refer to chapter 16 "Audio Multitasking".
20
Press the "ON" key three times.
Press the "ON" key three times.
Pairing up Menu
GPS Pair up
".
".
Publicidad
