Nolangroup N-Com X Serie Seguridad E Instrucciones página 59

3. At this point, system C can join the intercom conference call, establishing an intercom
connection with system A.
4. The three systems are now in intercom conference call mode and can talk to each other at
the same time.
5. In case you wish to add another system (D), the latter must be paired up beforehand to
system C. Press the relative connection command to start a 4-participant intercom
conference call.
Universal Conference
N.B.: The "
systems".
Universal Conference
N.B.: The "
with other N- Com devices (B601, B5, B1.4, etc.).
19. REMOTE CONTROL
The B902 device can be controlled by using a remote control (sold separately), so that you do not
have to take your hands off the handlebars to use the keypad.
The N-Com system is compatible with the RC4 Remote Control by SENA.
The following table shows the correspondence of the keys:
N-COM SYSTEM
SENA RC4
Proceed as follows to pair up the N-Com system to the RC4 Remote Control:
•
Make sure the RC4 is switched off.
•
Put the RC4 in pair up mode: press the "+"key and keep it pressed for about 8 seconds.
•
Make sure the B902 is switched off.
•
Put the B902 system in the "Pairing up" menu: press the "ON" key and keep it pressed for 4
seconds, until you hear the voice announcement "
•
Press "" key to access the "Remote control pair up" mode.
•
Press the "ON" key on the N-Com system keypad.
•
After a few seconds, the connection between the two devices is confirmed by the voice
Remote control connected
announcement "
N.B.: The affiliation is saved by both the helmet and the remote control and it is not lost when the two
systems are turned off. Hence this procedure must only be carried out once.
" mode can also be used by connecting only "900" series N-Com
" mode can also be used by connecting "900" series N-Com systems
▲ ▼ ON
+ - CENTRAL KEY
".
MULTI-FUNCTION KEY
Pairing up Menu ".
N
27