Philips AUT4030R400 Manual Del Usuario página 10

3. Installing the faucet
Note:
Select an appropriate installation position. The environment where the faucet is installed
should adhere to any appropriate hygiene and sanitation conditions.
Make sure the faucet sits �at on top of the sink or countertop surface.
a. Drill a hole with a diameter of 26-35mm.
Skip this step if there is already a hole in the
sink or the countertop surface.
b. Install the faucet according to the diagram.
Screw the faucet rod nuts to the faucet rod,
and screw them tightly.
Under the sink or countertop, insert the inlet
pipes of the faucet into the quick connectors
and use clips to secure the pipes.
4. Installing the system
Note:
Please check if there is sufficient space for installing the system itself, its accessories,
connections, and for servicing and repair. Under no circumstances should the system be
installed outdoors. The environment where the system is installed should adhere to any
appropriate hygiene and sanitation conditions. Avoid any external dripping liquids from
pipes or drains etc onto the system.
This system should be placed on a stable and lat surface. Keep the system away from
heat. It shall not be placed in a place that may have in�ammable gas leakage.
a. Find a proper place for the system
Handle
Surface
Puri�ed water
inlet pipe (white)
7
Water outlet
Base
Rubber washer
Rubber washer
Nut
Filtered water
inlet pipe (yellow)
Quick connector