Wilfa ESSENTIAL AUTO Manual De Instrucciones página 12

INSTRUCTION MANUAL · ESSENTIAL 1500/1200 AUTO
USING THE APPLIANCE
EN
• There is a jar sensor on the blender base. When blender jar is placed on the
unit, all the functions and time controls can be selected.
• Make sure the indicator is set to off when you start the blender.
• Put the desired ingredients into the jug.
• Mount the lid onto the jug and insert the lid cap or tamper.
• Select the desired pre-set by turning the knob clockwise to mode, and
press your preferred program. The product will run the selected program
automatically, after program is completed, the blender will enter standby
mode.
• Select speed manually by turning the knob clockwise.
• Manual Pulse: Press and hold Pulse. The motor will increase to full speed, and
stops when you release. When releasing, the product will return to standby
mode.
Note: It is recommended to cut the meat or other food into smaller pieces
before putting them in the jar. Do not operate with large quantities of food at
one time.
CLEANING
Note: Always clean the removable parts immediately after use.
Note: Be careful when cleaning the parts. Avoid touching the sharp blades!
• Disconnect the power from main supply.
• Disassemble all removable parts before cleaning.
• Clean all removable parts in lukewarm water with dishwashing liquid.
• The blender jug can be rinsed with water. It can also be cleaned by pouring
warm water into the jug with a few drops of dishwashing liquid, and press the
pulse button until it looks clean. Pour out the water, rinse and dry with a soft
cloth.
• Use dry cloth to clean the main body.
10