Publicidad
Idiomas disponibles
Idiomas disponibles
Pressure Washer Rinsing
1.
Engagetrigger lock on spray gun.
2.
If using cleaning tank, rotate detergent shut-off valve all
cleaning tank to "Off" position.
3.
Remove biack spray tip from nozzle extension.
4.
Select and instaii desired high pressure spray tip
following instructions How to Use Spray Tips.
5.
Keep spray gun a safe distance from spray surface.
WARNING
Kickback from spray gun can cause you to fall=
* Operate pressure wasberfrom a stablesurface.
o Be extremely carefulif you rnustusetbe pressure washerfrom
a ladder,scaf%ding,or anyotberelevated location.
, Firmlygraspspraygun witb bothhandswhenusinghigb
pressure sprayto avoidinjury wbeospraygun kicks back.
6.
Apply a high pressure spray to a smaii area and then
check surface for damage. If no damageis found, you
can assume it is okay to continue rinsing.
Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
.
Cteaning Detergent $iphening Tehe
If you used the detergent siphoning tube, you must flush it
with ctean water before stopping the engine.
1.
Piace detergent siphoning tube/filter in a bucket full of
clean water.
2.
Remove high pressure spray tip from nozzle extension.
3.
Select and instaii black detergent spray tip following
instructions How to Use Spray Tips.
4.
Flush for 1-2 minutes.
5.
Shut off engine foiiowing instructions How to Stop
Pressure Washerand turn off water suppiy.
6.
ALWAYS point spray gun in a safe direction and squeeze
spray gun trigger to release retained high water
press u re.
iMPORTANT:Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
_
nderIying tissues, ieading to serious injupj and
)ossible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injupj.
o Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYS pointspraygun in safedirectionand squeeze spray
gun trigger,to release high pressure,everytime you stop
engine.Engage trigger lockwhennot in use.
Aatematic Ceel #ewn System
(Thermal Relief)
If you run the engine on your pressure washer for
3=5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125%. The system engagesto cooI the pump by dis¢harging
the warm water onto the ground.
14
Publicidad
