Publicidad
Idiomas disponibles
Idiomas disponibles
Your c leaning system requires some assembly andisready
foruse onlyafter i t hasbeen properly servbed w iththe
recommended
oilandfuel.
Jfyou
have any prahtems with the assemMy of your
pressurewasher, please call the pressurewasher hempline
at 1-800-222-3136.
UNPACKTHE PRESSURE WASHER
1.
Remove everything from carton except pressure washer.
2.
Open carton completeiy by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
CARTONCONTENTS
CheckalI contents. If any parts are missing or damaged, call
the pressure washer hetpline at 1-8e0-222-3136.
o The main unit
,
Handle
,
Cbaning tank assembly
*
Spray gun
,
High pressure hose
o
Nozzleextension with quick connect fitting and nozzle
holder
o
Engine oiI
°
Detergentsiphoning hose/filter
,
Parts bag (which inciudes items listed below)
,
Safety goggles
o
Owner's manual
°
Gun holder wireform
o
Registration card
°
Bagcontaining 4 multi-cotored quick connect spray
tips
°
Handlefastening hardware kit (which includes):
o
Carriage bolt (2)
,
L hook (1)
°
Plastic knobs (4)
o
Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer. CheckalI contents against the illustration
on page 6. If any parts are missing or damaged, calI the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGYOURPRESSURE WASHER
Your Craftsman Hgh pressure washer was mostly assembied
at the factory. However,you wiii need to perform these tasks
before you can operateyour pressure washer:
1.
Fiii out and send in registration card.
2.
Attach handie and cieaning tank assembly.
3.
Attach detergent siphon hose to pump.
4.
Add oii to engine crankcase.
5.
Add fuel to fuel tank.
6.
Connect pressure hose to spray gun and pump.
7.
Connectwater suppiy to pump.
8.
Attach nozzieextension to spray gun.
9.
Select/attach quick connect spray tip to nozzb extension.
Attach Handle and Cleaning Tank
1.
Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
NOTE:it may be necessary to move the handie supports
from side to side in order to aiign the handle so it wifl sfide
over the handb supports.
2.
Insert carriage bolts (A) througll holes from back of unit
and attach a plastic knob (B) from front of unit. Tighten
by hand.
Placecteaning tank (B) over holes (C) on handb
(viewing from front of unit). Push the tree clips (A) into
the holes until they sit fiat against the cleaning tank.
/
/
/
Insert "L" bait (A) througil hole ust abovecleaning tank
on right side of handle (viewing from front of unit). Hold
bait in place and attach plastic knob (B) from inside of
unit. Tighten by hand.
Publicidad
