TOSHIBA TEC Corporation B-852-TS12-QP Manual De Instrucciones página 22

2. PRINTER SETUP
2.7.3 Loading Media into the
Printer (Cont.)
10. After loading the media, don't forget to move the Supply Holder
Unit to the forward notch of the Supply Roll Frame as shown below.
11. If you are using labels or thick tag paper, then it may be necessary to
increase the head pressure by lowering the Head Pressure Adjust
Lever in the figure below.
Head Pressure Adjust Lever
NOTE: Head Pressure Adjust Lever Position
Lever position Head pressure
UP
DOWN
•
When using full width media, be sure to turn the Head Pressure Adjust
Lever to DOWN, regardless of the thickness.
•
For all kinds of media except the full width media, turn the Head Pressure
Adjust Lever to UP, if the print quality is to be ensured.
•
If the print tone is light when using thin tag paper, turn the Head Pressure
Adjust Lever to DOWN.
E2-11
ENGLISH VERSION EO1-33028
Available media
•Thin tag paper
Low
•Narrow media
•Label
•Thick tag paper
High
•Wide media
•Full width media
2.7 Loading the Media
UP
DOWN