Appendix 3 Interface - TOSHIBA TEC Corporation B-852-TS12-QP Manual De Instrucciones

APPENDIX 3 INTERFACE

APPENDIX 3 INTERFACE
Interface Cables
To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:
•
Fully shielded and fitted with metal or metallized connector housings.
•
Keep as short as possible.
•
Should not be bundled tightly with power cords.
•
Should not be tied to power line conduits.
RS-232C Cable description
The serial data cable used to connect the printer to the host compute should be one of the following two types:
Connector to PC
Pin No.
1
2
3
4
5
6
7
8
9
Housing
Connector to PC
Pin No.
1
2
3
4
5
6
7
20
NOTE:
Use an RS-232C cable with inch type securing screws on the connector.
DB-9S
Signal
N.C.
RXD
TXD
DTR
GND
DSR
RTS
CTS
N.C.
Shield
DB-25S
Signal
Shield
TXD
RXD
RTS
CTS
DSR
GND
DTR
DB-9P
Connector to Printer
Pin No. Signal
1 N.C.
2 TXD
3 RXD
4 DSR
5 SG
6 DTR
7 CTS
8 RTS
9 N.C.
Housing Shield
DB-9P
Connector to Printer
Pin No. Signal
1 N.C.
2 TXD
3 RXD
4 DSR
5 SG
6 DTR
7 CTS
8 RTS
9 N.C.
EA3-1
ENGLISH VERSION EO1-33028
APPENDIX 3 INTERFACE