A1.4 Ribbon - TOSHIBA TEC Corporation B-852-TS12-QP Manual De Instrucciones

APPENDIX 1 SPECIFICATIONS

A1.4 Ribbon

Please make sure that the ribbon being used is approved by TOSHIBA TEC. The warranty does not apply to any
problem caused by using non-approved ribbons.
For information regarding TOSHIBA TEC approved ribbon, please contact a sales representative.
Type
Width
Length
Outside Diameter
The table below shows the correlation between ribbon width and media width (backing paper is not included).
Ribbon width
120 mm
160 mm
220 mm
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified ribbons.
2. To avoid ribbon wrinkles use a ribbon that is wider than the media by 10 mm or more. However, too
much difference in width between the two may cause wrinkles.
Spool type
120 – 220 mm
Recommended width is 120, 160 and 220 mm.
300 m
φ72 mm (max.)
Media width
100 – 110 mm
110 – 150 mm
150 – 242 mm
EA1- 5
ENGLISH VERSION EO1-33028
A1.4 Ribbon