Facom DX.V12A Guía De Instrucciones página 9

If the FACOM DX.V12A detect a PWM signal the screen go red a PWM with
logo is show with an alarm. This function is just a indicator. It is useful to find
where is a PWM line in a connector or to avoid mistakes.
5.4 "V" MODE (VOLTMETER MODE) : ERROR MESSAGE
in
6.1 "Ω" MODE (OHMMETER MODE) : MEASURE A RESISTANCE
Remember : DX.V12A is able to measure resistance from 0 Ω to 40MΩ.
he
• Press the Ω button to select the Ω mode.
• Connect the test lead to the DX.V12A terminal.
with
• Connect the test lead to the components where you need to measure the
resistance. DX.V12A show the resistance in Ω, KΩ, MΩ.
6.2 "Ω" MODE (OHMMETER MODE) : CONTINUITY INDICATOR
If the measured resistance in less than 30Ω the LCD screen go green the
continuity symbol was show with an alarm.
6.3 "Ω" MODE (OHMMETER MODE) : OVER LIMIT ALARM
red
During resistance measure if the circuit is open or if the resistance is higher
than 40MΩ the LCD screen goes red with an alarm and shows OL. (Over
Limit).
DISPOSAL OF THIS ARTICLE
e.
Dear Customer,
e.
If you at some point intend to dispose of this article, then
please keep in mind that many of its components consist
of valuable materials, which can be recycled.
Please do not discharge it in the garbage bin, but check
with your local council for recycling facilities in your area.
If the DX.V12A is used on higher than 49V volt circuit a error
«ERR» is show with an alarm.
Any voltage up to 49V cannot be measured by the DX.V12A.