Johnson GreenBrite JLD300-GN2D Manual De Instrucciones página 11

6. Operation Instructions
IMPORTANT: It is the responsibility of the user to verify the
calibration of the instrument before each use. See section 7.
Using the Cross-Line & 2 Dot Laser
1. Mounting Positions
The Johnson Cross-Line & 2 Dot Laser can be mounted in a variety
of positions, depending on your needs.
Place the unit in an upright position, either on a stable, flat surface,
mount it to a tripod with a 1/4"-20 threaded screw, mount it to a
ferrous surface using the magnets, or hang it on a nail using the
mounting hole. Non-mar rubber feet on the unit prevent damage to
surfaces. (Figure 9)
©2023 Johnson Level & Tool
1/4"-20 Screw Thread
Figure 9
Mounting Hole
Mounting
Magnets
Non-mar
Rubber Feet
11