Vacuum System Motor Filter Cleaning; Solution Filter Cleaning - Clarke FOCUS II Micro Rider Instrucciones De Uso

ENGLISH

VACUUM SYSTEM MOTOR FILTER CLEANING

Drive the machine on a level loor.
1.
2. Turn the ignition key (58) to "0".
3. Open the cover (20) and check that the recovery tank (19) is empty, otherwise empty it with the drain hose (24).
4. Close the cover (20).
5. Carefully lift the tank assembly (19) from left side.
Check that the ilter (37) is clean. If necessary clean it with water and compressed air, then reinstall it.
6.

SOLUTION FILTER CLEANING

Drive the machine on a level loor.
1.
2. Turn the ignition key (58) to "0".
3. Close the solution tap (A, Fig. 10) under the machine, behind the right rear wheel. The tap (A) is closed when it is in the
position (B) and it is open when it is in the position (C).
Remove the transparent cover (D) and the gasket (E), then remove the ilter strainer (F). Clean them with water and install
4.
them on the support (G).
NOTE
The ilter strainer (F) must be correctly positioned on the housing (H) of the transparent cover (D).
5. Open the tap (A).
C
A
24
INSTRUCTIONS FOR USE
B
FOCUS II Micro Rider - 9099236000
G
F
E
D
Figure 10
H
P100444
7/11