Palm 11621 Manual Del Usuario página 4

1-2-3 STEPS OF FITTING A PFD
1 2 3
1 Loosen all straps and buckles.
2 Don the PFD, either over the head or by front entry, and fasten any buckles.
3 Tighten all straps, starting from the waist and working upwards to the
shoulder straps. Finish by sitting down and checking the shoulder strap length
– retighten if necessary.
QUICK RELEASE CHEST HARNESS - IF FITTED
This PFD is fitted with a Palm chest harness designed to meet the ISO safety
standard providing it is set up correctly. Please follow the steps below:
3cm
1 2 3
1 Thread the webbing through the metal load spreader and then through the
plastic cam buckle as shown.
2 Close the cam buckle leaving 3cm of loose webbing and ensuring the
release knob is accessible. Tighten the chest harness using the side metal
tension lock buckle until any slack is taken up and stow any loose webbing.
3 Test by pulling the release knob until the cam buckle is fully open - the loose
webbing should pull out of the plastic cam buckle completely.
2