Cherubini META Dry Contact Switch 7 Instrucciones página 27

TECHNICAL SPECIFICATIONS
Power supply
Maximum Load on Relay
System temperature limitation 105 °C
Work temperature
Power consumption
Radio frequency
Protection system
Maximum distance
Dimensions
Actuator element
Compliance
Electrical IP Rating
SAFETY INFORMATION
INFO: The device is designed to be installed in flush mounting junction boxes or
close to the load to be controlled.
WARNING: The device must be installed by electricians qualified to intervene
on electrical systems in compliance with safety requirements set out by the
regulations in force.
DANGER: The device must be connected with a voltage of 230 VAC, before
carrying out any operation, please make sure the power main switch is in OFF
position.
DANGER: Any procedure requiring the use of the Integrated Button is related
only to the installation phase and is to be considered a service procedure that
must be performed by qualified personnel. This operation must be performed
with all necessary precautions for operating in areas with a single level of
insulation.
WARNING: Do not connect loads that exceed the maximum load permitted by
the actuator element.
WARNING: All connections must be performed according to the electrical
diagrams provided.
WARNING: The device must be installed in norm-compliant systems suitably
protected from overloads and short circuits.
110 - 230 VAC ± 10% 50/60 Hz - 24 VDC
16A resistive Load
From -10° to 40° C
< 260 mW in standby
< 480 mW with working load
868,4 MHz
S2 Security
Up to 100 m outdoor
Up to 40 m indoor
37x37x17 mm
16 Amp relay
CE, RoHs
IP20
27