Husqvarna S 138C Manual De Usuario página 14

Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, disconnect the power cord.
To assemble the handle
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 24)
3. Set the handle height in one of the 2 available
positions.
4. Move the knobs up in the direction of the handle until
they stop and you hear a click. (Fig. 25)
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To set the work depth
WARNING:
depth when you operate the product.
14
Assembly
Before you assemble the
To prevent accidental start
Operation
Before you operate the
Do not adjust the work
5. Tighten the knobs fully.
To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag. (Fig. 26)
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips. (Fig. 27)
4. Lift the rear cover.
5. Move the grass catcher into the correct position.
(Fig. 28)
6. Attach the grass catcher to the top edge of the
chassis. Make sure that the rear cover seals against
the grass catcher to prevent leakage. (Fig. 29)
1. Push and turn the adjustment knob for the work
depth counterclockwise to increase the work depth.
2. Push and turn the adjustment knob for the work
depth clockwise to decrease the work depth. (Fig.
30)
To start the product
1. Connect a power cord to the socket below the
handle. (Fig. 31)
2. Put the power cord in the power cord holder. Refer
To use the power cord holder on page 12 . (Fig.
to
23)
3. Stay behind the product.
4. Loosen the start inhibitor. (Fig. 32)
5. Push the motor brake handle in the direction of the
handlebar. (Fig. 33)
To stop the product
1. Release the motor brake handle to stop the motor.
(Fig. 34)
2. Disconnect the power cord from the mains and then
from the product. (Fig. 35)
CAUTION:
out. Do not pull the power cord.
Pull the plug straight
2368 - 002 -