Publicidad
Idiomas disponibles
Idiomas disponibles
Caution, very bright light.
Replace any damaged or cracked protection screen shields.
Only use indoors.
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in some
details may differ from the actual product.
2. Usage safety
ATTENTION!
Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury or even death.
The terms "device" or "product" are used in the warnings and instructions to refer to:
Beam Moving Head
Spot Moving Head
Moving Head Light
2.1.
Electrical safety
a)
The plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device is exposed to rain, comes into direct contact with
a wet surface or is operating in a damp environment. Water getting into the device increases the risk
of damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it to carry the device or to pull the plug out of a
socket. Keep the cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled
cables increase the risk of electric shock.
e)
If using the device in a damp environment cannot be avoided, a residual current device (RCD) should
be applied. The use of an RCD reduces the risk of electric shock.
f)
Do not use the device if the power cord is damaged or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or the manufacturer's service centre.
g)
To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use
the device on wet surfaces.
2.2.
Safety in the workplace
a)
If there are any doubts as to the correct operation of the device, contact the manufacturer's support
service.
b)
Only the manufacturer's service point may repair the device. Do not attempt any repairs
independently!
c)
In case of fire, use a powder or carbon dioxide (CO
electrical devices) to put it out.
d)
Please keep this manual available for future reference. If this device is passed on to a third party, the
manual must be passed on with it.
e)
Keep packaging elements and small assembly parts in a place not available to children.
f)
Keep the device away from children and animals.
g)
If this device is used together with another equipment, the remaining instructions for use shall also be
followed.
Remember! When using the device, protect children and other bystanders.
EN
) fire extinguisher (one intended for use on live
2
Publicidad
