Grip Rite GRTSM2016C Manual Del Operador página 17

Tool operates, but no
fastener is driven.
Tool won't operate
staple jammed in tool
nose, preventing tool
from operating.
Tool leaks air.
TOOL CHECKS
Keep your nailer in top working condition by checking it daily.
See your Grip-Rite
are found. Never use a malfunctioning tool – it could result
in serious injury.
WORKPIECE CONTACT & TRIGGER
Check workpiece contact for proper operation before each use.
Workpiece contact must move freely and return to extended position
when lifted from workpiece. Trigger must operate freely.
DAILY INSPECTION
• Check for broken, damaged, or excessively worn parts, and repair
or replace as needed.
• Check for air leaks at trigger, cap, and nose. Disconnect tool from
air supply immediately if leaks are present, and see dealer for service.
• Make sure all screws are tightened securely.
GRTSM2016C_OwnersManual007_ENGES.indd 17
FASTENER DRIVING PROBLEMS
dealer for service if part or operating problems
®
17
TROUBLESHOOTING
Check nose for jammed fastener.
Clear jam and reload magazine.
Check staple strips for smooth
feeding in magazine.
Remove jammed fastener.
Check magazine for incorrect, bent,
or loose fasteners, and discard.
Reload using Grip-Rite staples.
®
Check for source of leak, and tighten
fittings and screws as required.
Discontinue using tool if air leaks
at trigger area or from cap exhaust.
Contact your dealer.
4/19/19 10:47 AM