Clatronic FS 3261 Manual De Instrucciones página 25

• Cleaning and user maintenance shall not be made by children
without supervision.
Unpacking the Appliance
1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
ties and cardboard.
3. Check the delivery contents for completeness.
4. Take the adhesive strips off the foil roll.
5. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the
appliance. We recommend to clean the appliance as
described under "Cleaning".
Overview of the Components /
Scope of Delivery
1 Lid
2 Housing
3 VACUUM control lamp "Suction"
4 SEAL control lamp "Heat-sealing"
5 Suction nozzle
6 Heat-sealing wire
7 Heat-sealing foil
Not shown
Cable take-up
Notes for Use
1. Unwind the power cord from the bottom of the appliance.
2. Ensure that the mains power corresponds to the one of
the appliance. Please refer to the specifications on the
type label.
3. Connect the supply cord to a properly installed grounding
receptacle.
WARNING:
• Always remove the mains plug before cleaning. Wait until the
appliance has cooled down.
FS3261_IM_new2
4. In order to form a bag from the roller foil, unroll the
required part of the foil (max. 29 cm) (fig. B) and separate
this by heat-sealing (fig. C + F).
5. Fill the bag.
6. Remove the remaining air out of the bag by suction and
then heat-seal it.
CAUTION: Short-time operating
The appliance should only be left switched on for 13 sec-
onds. This should then be followed by a break of at least
90 seconds.
Removing Air by Suction
1. Open the lid and place the suction nozzle in the bag. The
top and bottom of the bag must be lying flat on the foam
material edge next to the suction nozzle (fig. D).
2. Close the lid and press only the left edge of the lid down.
Air is now sucked out of the bag (fig. E).
CAUTION:
Ensure that no liquid is sucked up.
Heat-sealing
1. Press down the lid on both sides. The red control lamp
for "VACUUM" and the green one for "SEAL" illuminate.
2. As soon as the green control lamp goes out the lid may
be opened. The heat-sealing operation is now complete
(fig. G).
3. Gently release both parts of the foil from the heat-sealing
wire (fig. G).
Finish Operation
• Remove the plug from the receptacle.
• Allow the appliance to cool down for 5 minutes prior to
storage.
Cleaning
Operation
09.09.21
25