jbc Pulsmatic 55N Instrucciones De Funcionamiento página 4

Before using this equipment, we recommend you read these instructions carefully.
TECHNICAL DATA:
Reference
Power supply
Power
Maximum temp.
Time to reach ...
Schuko-Plug
Connection
- C-20D Long-life tip (1x)
Includes
- SN5450 Solder reel (1x)
INSTRUCTIONS FOR USE
Check that the mains voltage is the same as
specified on the unit.
Do not plug in the soldering iron without a tip, as
this might damage the heating element.
To avoid incidents, the hot soldering iron should
be kept inside the TS1200 Stand, which is sold
separately.
REPLACING THE REEL
The reel is pressed into the support arm, where
it is held in place.
To extract the reel, rest the shaft end on a
convenient surface and press down on the reel
until it is released (1).
Before fitting a new reel, pull out the solder wire
remaining inside the guide tube (2).
4
2552016 9553074
230V 24V
33W
450 ºC
- 250 ºC: 2 min.
- 300 ºC: 3 min.
no Plug
(type F) (2-core cable)
2
The solder flux may cause clogging at the end of
the guide tube: clean when necessary.
To fit the new reel, position it in such a way that
the solder wire runs off at the bottom (3); insert
the end of the wire into the tool (4) and manually
feed it in until it can be fed using the trigger.
Note: Always use a 1 mm diameter solder wire.
SOLDER REEL TYPES
Solder reel with ø 1 mm solder wire.
Alloy: 99%Sn / 0.3%Ag / 0.7%Cu - 50 g
Green solder reel: SN5450
1
ENGLISH
Guide Tube
Support Arm
Solder Reel
4
Solder
Wire
3