Black and Decker BDRV1 Manual De Instrucciones página 10

SETTING UP THE CHARGING DOCK
ABOUT YOUR CHARGING DOCK
SETTING UP THE CHARGING DOCK
Plug the power adapter into the port on the bottom of the charging
1
dock and secure the cable into the channel.
Place the charging dock against the wall and make sure the place is an open & uncluttered area. Leaving at least 5 feet in
front of the charging dock and 2 feet on both sides of the charging dock.
NOTE: Clearance around the charging base is necessary to prevent obstructions when the Vacuum returns to charge.
Avoid using a power source that may inadvertently be switched off (e.g. power strip, outlet controlled by a light switch,
GFCI).
2
1
Choose a location on a hard floor surface near a power outlet. Place the charging dock
against the wall as shown. Plug the power adapter into a functioning wall outlet.
8