Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 11 Power on
Plug the power cord into a wall socket protected by a fuse or circuit breaker. Then, tap
Laundry Hub.
For gas models
Make sure all gas connections, the exhaust line, and all wiring is connected correctly. Then, plug the
power cord into a power source and check the dryer's installation and operation using the final checklist in
Step 12.
STEP 12 Final Check
When installation is complete, confirm that:
• The Laundry Hub is plugged into an electrical outlet and grounded properly.
• The exhaust ductwork is connected, and the joints are taped.
• You have used rigid or stiff-walled flexible metal duct material, not plastic flexible duct.
• The Laundry Hub is level and is sitting firmly on the floor.
• The dryer starts, runs, heats, and shuts off properly.
• The gas is supplied properly with no leaks (For gas models only).
CAUTION
The burner may not ignite initially due to air in the gas line. Allowing your dryer to operate on a heat setting
will purge the line. If the gas does not ignite within 5 minutes, turn the dryer off and wait 5 minutes. Be
sure the gas supply to the dryer has been turned on. To confirm gas ignition, check the exhaust for heat.
Untitled-1 43
to turn on the
English 43
2023-11-09( )
11:53:38
Publicidad
