Origin 21 149070 Manual De Instrucciones página 12

ASSEMBLY INSTRUCTIONS
9. Attaching the Base
• Align the pre-installed hardware on the edges
of the Left and Right Inside Panels (D and E)
with the predrilled holes in Base (A), as shown.
• Secure the Left and Right Inside Panels (D and
E) to Base (A) by tightening the screws (CC)
with a Phillips screwdriver as shown.
Hardware Used
Ø4x50mm
CC
Screw
10. Attaching the back panels
• Locate the Side Back Panels (J).
• Slide the Side Back Panels (J) into the grooves
between the inner and outer side panels as
shown. Slide all the way toward the center.
11. Attaching the side panels
• Locate the Left and Right Side Panels (K and L).
• Align the Left and Right Side Panels (K and L)
with ends of the main assembly, as shown.
• Insert the pre-installed dowels and screws on the
ends of the main assembly into the pre-drilled
holes in the Left and Right Side Panels (K and L)
as shown.
• Secure the Left and Right Side Panels (K and L)
to ends of the main assembly by tightening the
fasteners with a Phillips screwdriver as shown.
23MMP35115REV1.0
9
x 4
10
J
11
K
12
A
J
L