Publicidad
PSEN sl-0.5p 4.1/4.2
Datos mecánicos
Material
Lado superior
Placa de fijación
Placa base
Accionador
Par de apriete máx. tornillos de fija-
ción
Dimensiones
Altura
ancho
Profundidad
Dimensiones accionador
Altura
ancho
Profundidad
Peso interruptor de seguridad
Peso accionador
Peso
Para referencias a normativas valen las 2015-04 versiones más actuales.
Datos complementarios
Homologación de equipos inalámbricos
USA/Canada
VT8-PSENSLP
FCC ID:
IC:
7482A-PSENSLP
FCC/IC-Requirements:
This product complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standards.
Operation is subject to the following two conditions:
1) this product may not cause harmful interference, and
2) this product must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made to this product not expressly approved by Pilz may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Le présent produit est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) le produit ne doit pas produire de brouillage, et
(2) l'utilisateur de le produit doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Manual de instrucciones PSEN sl-0.5p 4.1/4.2
1003807-ES-04
570574
PBT
Acero niquelado
Anticorodal, anodizado duro
Anticorodal, anodizado duro
3 Nm
122 mm
45 mm
44 mm
138 mm
52 mm
23 mm
570 g
365 g
940 g
570575
PBT
Acero niquelado
Anticorodal, anodizado duro
Anticorodal, anodizado duro
3 Nm
122 mm
45 mm
44 mm
138 mm
52 mm
23 mm
570 g
365 g
940 g
| 39
Publicidad
