Descargar Imprimir esta página

Craftsman 580.752910 Manual Del Operador página 7

Ocultar thumbs Ver también para 580.752910:

Publicidad

Idiomas disponibles

Idiomas disponibles

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1=800-222-3136.
UNPACK THEPRESSURE WASHER
1.
Removeeverything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
7.
Connectwater supply to pump.
8.
Attach nozzleextension to spray gun.
9.
Select/attach quick connect spray tip to nozzle extension.
Attach Handleand Accessory Tray
1.
Place handle (A) onto handle supports connected to
main unit. Make sure holes in handle align with holes on
handle supports.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
Main Unit
Handle
Accessory Tray with Hose Wrap
High Pressure Hose
Spray Gun
Nozzle Extensionwith Quick Connect Fitting
Oil Bottle
Bottle Bracket Wireform
PerfectMix
TM
Siphoning Unit/Hose
Parts Bag (which includes the following):
Operator's Manual
Owner's Registration Card
Bag containing 4 Multi-Colored Quick Connect Spray
Tips
Handle FasteningHardware Kit (which includes):
Handle Bolts (2)
CarriageBolt (1)
Plastic Knobs for Handle(2)
Plastic Knob (1)
Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer, identify aii contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1.
Fill out and send in registration card.
2.
Attach handle and accessory tray.
3.
Connect detergent siphon hose to pump.
4.
Add oil to engine crankcase.
5.
Add fuel to fuel tank.
6.
Connect pressure hose to spray gun and pump.
2.
insert handle carriage bolts (B) through holes from
inside of unit and attach a plastic knob (C) from outside
of unit. Tighten by hand.
NOTICE By loosening both knobs to the middle section of
the attachment bolt, the upper handle can fold forward to
store fiat atop the cold engine. DONOTfold the handle down
while the engine is hot.
3.
insert rubber straps (D) through slots (E) in back of
accessorytray and pull tight from front.

Publicidad

loading