Kenwood Multipro Compact FDP301 Instrucciones página 6

grinding mill
To ensure the long life of your grinding mill, never run for longer than 60
l
seconds. Switch off as soon as you have got the right consistency.
Do not process turmeric root as it is too hard and may damage the
l
blades.
slicing/grating disc
Never remove the lid until the cutting disc has completely stopped.
l
Handle the cutting discs with care - they are extremely sharp.
l
before plugging in
Make sure your electricity supply is the same as the one
l
shown on the underside of your appliance.
This appliance conforms to EC Regulation 1935/2004 on
l
materials and articles intended to come into contact with
food.
before using for the first time
1 Remove the plastic blade covers from the knife blade.
Take care the blades are very sharp. These covers
should be discarded as they are to protect the blade during
manufacture and transit only.
2 Wash the parts see "care and cleaning".
key
processor
pusher
1
feed tube
2
lid
3
bowl
4
detachable drive shaft
5
power unit
6
speed/pulse control
7
safety interlocks
8
cord storage (at back)
9
attachments
Not all of the attachments listed below may be included with
your food processor. Attachments are dependent upon the
model variant. Refer to "service and customer care" section
for information on how to buy an attachment not included in
pack.
blender
(if supplied)
blade assembly

sealing ring

goblet

filler cap

lid

mini chopper /mill
blade assembly

sealing ring

jar

(if supplied)
grinding mill
(if supplied)
mill lid

grinding mill blade assembly

knife blade

dough tool (if supplied)

emulsifying tool

thick slicing/coarse grating disc

citrus juicer (if supplied)

thin slicing/fine grating disc (if supplied)

to use your food processor
1 Fit the detachable drive shaft onto the power unit
2 Then fit the bowl by aligning the
on the power unit, turn clockwise
3 Fit an attachment over the bowl drive shaft.
Always fit the bowl and attachment onto the processor
l
before adding ingredients.
4 Fit the lid - ensuring the top of the drive shaft/tool locates
3
into the centre of the lid.
Do not use the lid to operate the processor,
l
always use the on/off speed control.
5 Plug in, switch on and select a speed. (Refer to the
recommended speed chart).
The processor will not operate if the bowl or lid
l
are not fitted correctly into the interlock. Check
that the feed tube and bowl handle are situated
to the right front hand corner.
Use the pulse (P) for short bursts. The pulse will operate for
l
as long as the control is held in position.
6 Reverse the above procedure to remove the lid, attachments
and bowl.
Always switch off and unplug before removing the
l
lid.
important
Your processor is not suitable for crushing or grinding coffee
l
beans, or converting granulated sugar to caster sugar.
When adding almond essence or flavouring to mixtures avoid
l
contact with the plastic as this may result in permanent
marking.
4
.
1
on the bowl with the
until it locks .
2