• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
• The
appliance
accordance
with
regulations.
READ THIS SECTION BEFORE ATTEMPTING
TO OPERATE AIR CONDITIONER.
Unit must be upright for one hour prior to
operating.
Operation of Current Device
The power supply cord contains a current
device that senses damage to the power
cord. To test your power supply cord do the
following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO
buttons on the plug head. Press the TEST
button. You will notice a click as the
RESET button pops out.
3. Press the RESET button. Again you will
notice a click as the button engages.
4. The power supply cord is now supplying
electricity to the unit. (This is also
indicated by a light on the plug head).
Plug in & press RESET
IMPORTANT SAFETY INSTRUCTIONS
shall
be
installed
national
wiring
NOTE
• Do not use this device to turn the unit on or
off.
in
• Always make sure the RESET button is
pushed in for correct operation.
• The power supply cord must be replaced if
it fails to reset when either the TEST
button is pushed, or it cannot be reset. A
new one can be obtained from the product
manufacturer.
• If power supply cord is damaged, it
CANNOT be repaired. It MUST be replaced
by
one
obtained
manufacturer.
WARNING
FOR FLAMMABLE REFRIGERANT
• Servicing shall only be performed as
recommended
manufacturer. Maintenance and repair
requiring the assistance of other skilled
personnel shall be carried out under the
supervision of the person competent in
the use of flammable refrigerants.
• DO NOT modify the length of the power
cord or use an extension cord to power
the unit.
• DO NOT share a single outlet with other
electrical appliances. Improper power
supply can cause fire or electrical shock.
• Please follow the instruction carefully to
handle, install, clear, service the air
conditioner to avoid any damage or
hazard.
• Flammable Refrigerant R32 is used within
air conditioner. When maintaining or
disposing
refrigerant
properly,
shall
directly.
• Compliance with national gas regulations
shall be observed.
• Keep
ventilation
obstruction.
• The appliance shall be stored so as to
prevent
mechanical
occurring.
from
the
by
the
the
air
conditioner,
(R32)
shall
be
not
discharge
openings
damage
5
product
equipment
the
recovered
to
air
clear
of
from