Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL
Preliminary Instructions
How to insert the batteries
Remove the cover from the battery compartment, by sliding it in the
direction of the arrow.
Insert the new batteries, ensuring that the (+) and (-) directions are
correct
Fit back the cover by sliding it into place.
Use 2 LRO 3 AAA (1.5V) batteries. Do not use rechargeable
batteries. Replace the old batteries with new ones of the same
type when the display is no longer legible.
The remote control batteries must be disposed of in accordance
with the applicable laws in force in the country of use.
Refer to picture 1:
i. When you insert the batteries for the first time in the remote
control or if you change them, you will see a DIP switch under
the back cover.
DIP switch on position Function
C
F
Cool
Heat
ii. BE CAREFUL: After adjusting the function, you need to take
out the batteries and repeat again the procedure described above.
Refer to picture 2:
When you insert the batteries for the first time in the remote
control or if you change them, you need to program the remote
control for cooling only or coo-heat.
This is very easy: as soon as you insert the batteries, the symbols
COOL
(
) and
whatever button when the symbol
remote control is adjusted in only cooling mode. If you push
whatever button when the symbol
the remote control is adjusted in heating mode.
BE CAREFUL: if you adjust the remote control in cooling mode,
it will not be possible to activate the heating function in units with
heating pump. you need to take out the batteries and repeat again
the procedure described above.
1. Direct the remote control toward the conditioner.
2. Check that there are no objects between the remote control
and the receiver on the conditioner.
3. Never leave the remote control exposed to the rays of the sun.
4. Keep the remote control at a distance of at least 1m from the
television or other electrical appliances.
Recommendations for locating and using the remote control (if present)
The remote control may be kept in a wall-mounted holder
Remote controller holder
The display is adjusted in degree celsius
The display is adjusted in degree fahrenheit.
The remote control is adjusted in only cooling mode
The remote control is adjusted in only heating mode
(
HEAT
) start fashing. If you push
(
COOL
(
HEAT
FEEL
COOL
DRY
FAN
HEAT
) is displayed, the
) is displayed,
9
FAN
FEEL
SPEED
COOL
AIR
DRY
SWING
FAN
HEAT
HEALTHY
HEALTHY
TIMER
Signal
receptor
FAN
SPEED
AIR
SWING
TIMER
Publicidad
